Hardware⏱️ 3 min read📅 2026-06-11

How to Fix XP-640 Error – "The printer is exposed to strong light" error on Epson XP-640

Epson XP-640 printer error: strong light exposure fix

Quick Answer: Try cleaning the printer's exterior and adjusting its position to reduce direct sunlight exposure.

📋 Table of Contents

  1. ⚠️ Common Causes
  2. ✅ Best Solutions to Fix It
  3. ✨ Wrapping Up

The 'The printer is exposed to strong light' error on Epson XP-640 is an unusual issue that may occur after performing maintenance tasks or replacing ink cartridges. This error message can be frustrating, as it prevents you from using your printer effectively. However, with the right troubleshooting steps, you should be able to resolve this issue and get back to printing.

It's essential to note that this error is likely related to a specific hardware component within the printer, rather than a software issue. By following these steps, you can identify and potentially fix the root cause of the problem.

⚠️ Common Causes

  • The first main reason why this error happens in detail is due to dust or debris accumulation inside the printer's LED light source. When you performed a deep clean on your Epson XP-640 printer and replaced the ink cartridges, it's possible that some cleaning solution or debris may have entered the printer's internal components. This could have affected the LED light source, causing the error message.
  • An alternative reason for this error is a faulty or damaged LED light source within the printer. In rare cases, the LED light source may be malfunctioning due to wear and tear or manufacturing defects.

✅ Best Solutions to Fix It

Cleaning the LED Light Source

  1. Step 1: Turn off the printer and unplug it from the power source.
  2. Step 2: Locate the LED light source, which is usually located at the back of the printer. You may need to refer to your printer's manual or online documentation for specific instructions on how to access this component.
  3. Step 3: Use a soft brush or a cotton swab to gently clean out any dust or debris from the LED light source. Avoid using harsh chemicals or abrasive materials that could damage the component.

Replacing the LED Light Source

  1. Step 1: Purchase a replacement LED light source for your Epson XP-640 printer. You can find these parts online or at an authorized Epson dealer.
  2. Step 2: Carefully remove the old LED light source from the printer, taking note of any screws or clips that hold it in place. Dispose of the old component responsibly.

✨ Wrapping Up

By following these steps, you should be able to resolve the 'The printer is exposed to strong light' error on your Epson XP-640 printer. Remember to be patient and gentle when cleaning or replacing any internal components to avoid causing further damage. If you're still experiencing issues after attempting these fixes, it may be worth contacting an authorized Epson service center for further assistance.

Did this fix your problem?

If not, try searching for specific error codes.

🔍 Search Error Database

❓ Frequently Asked Questions

🛠️ Related Fixes

How to Fix: hidden network issues by identifying and removin

Resolve hidden network issues by identifying and removing a problemati

How to Fix: Discover why your SSD's full volume space isn't

Fix Discover why your SSD's full volume space isn't showing up in Disk

How to Fix: Lenovo LOQ performance issues by updating driver

Resolve Lenovo LOQ performance issues by updating drivers, running a d